Budget Monobloc Speed Bump 55 mm Height

One-Piece Speed Bump 1.83 m in Recycled Rubber – 55 mm Height – Up to 20 Tons

The 1.83 m monoblock speed bump made from recycled rubber is designed to provide a simple, effective, and more environmentally responsible solution for reducing vehicle speed without requiring heavy construction work or long road closures. With a 55 mm height, it helps reduce speed to around 25 km/h while remaining easy to install and suitable for a wide range of environments.

It is particularly well suited for private roads, light logistics areas, residential zones, and school surroundings.

Monoblock design for quick and clean installation

With its 1.83 m length and 300 mm width, this speed bump covers most traffic lanes with a single element. There is no need for assembly, alignment of modules, or complex adjustments.

Once installed and secured, the speed bump becomes stable, clearly visible, and immediately operational, making it ideal when rapid deployment is required without major site modifications.

55 mm height designed for controlled speed reduction

The 55 mm height creates enough constraint to encourage drivers to slow down while avoiding harsh impacts that could damage vehicle suspensions or sensitive loads.

It is optimized for a target speed of approximately 25 km/h, typical of residential areas, school zones, parking facilities, and low-speed internal roads.

Enhanced visibility day and night

The integrated reflectors reflect vehicle headlights back toward approaching drivers, ensuring the speed bump remains visible even in darkness, rain, or poorly lit areas.

Combined with its raised profile, this creates a permanent passive warning signal that helps drivers anticipate the obstacle safely.

Two integrated cable channels for network protection

The speed bump includes two Ø30 mm cable channels, allowing cables, hoses, or conduits to pass safely underneath without being exposed to crushing by vehicles.

This feature is particularly useful in temporary installations, event areas, or evolving technical sites.

Recycled rubber designed for real-world use

The recycled rubber construction offers a good balance between shock absorption, mechanical resistance, and environmental responsibility.

It is designed to support loads of up to 20 tons, making it suitable for cars, vans, and light-duty trucks.

Easy installation with included accessories

The speed bump is supplied with:

• asphalt fixings

• protective screw caps for a clean finish

This complete kit allows for quick installation without ordering additional accessories.

Technical specifications

Length: 1.83 m

Width: 300 mm

Height: 55 mm

Material: Recycled rubber

Target speed reduction: ≈ 25 km/h

Reflectors: Integrated

Cable channels: 2 channels Ø30 mm

Fixings: Included (for asphalt)

Caps: Included

Load capacity: Up to 20 tons

Applications: Private roads, logistics areas, residential zones, school surroundings

FAQ – One-piece recycled rubber speed bump

Is it compatible with trucks?

Yes, provided that the load remains within the 20-ton capacity, making it suitable for light-duty trucks and delivery vehicles.

Can it be used outdoors year-round?

Yes. Recycled rubber is designed to withstand weather conditions for road use.

Do the cable channels really protect cables?

Yes. The integrated channels protect cables and conduits from crushing under vehicle loads.

Is it suitable for school areas?

Yes. Its moderate height and high visibility make it well suited for school zones and residential streets.

Can it be installed on concrete?

Yes, using appropriate anchors designed for concrete surfaces if required.